#Putty ymodem file transfer how to
#Putty ymodem file transfer serial
#Putty ymodem file transfer manual

Note: xmodem options e, f, and s are only supported on the Cisco 1600 Series Routers. On the Cisco 1600 series routers, files are loaded to the ROMmon for execution. This argument is ignored when the -r keyword is specified since only one file can be copied to DRAM. This option is only valid for the Cisco 1600 series routers. The default rate is specified in the configuration register. (Optional) Sets the console port's data rate during file transfer. (Optional) Does not execute the Cisco IOS software image on completion of the download. (Optional) Erases all Flash memory before starting the download. This option is only valid for the Cisco 1600 series. (Optional) Erases the first partition in Flash memory before starting the download. (Optional) Uses the Ymodem protocol for higher throughput. (Optional) CRC-16 checksumming, which is more sophisticated and thorough than standard checksumming. This table describes the command syntax for the xmodem command.

#Putty ymodem file transfer manual

Here is the command syntax for xmodem as per the Command Reference Manual for Cisco IOS version 12.2. For example, downloading Cisco IOS Software Release 12.1(16) IP Plus image to a Cisco 1600 Series Router using a speed of 38400 bps takes approximately 25 minutes.

#Putty ymodem file transfer serial

Because this procedure relies on the console speed of the router and the serial port of the PC, it can take a long time to download an image. This procedure can also be used where there are no Trivial File Transfer Protocol (TFTP) servers or network connections, and a direct PC connection (or through a modem connection) to the router's console is the only viable option. Xmodem can be used on a group of routers (see Components Used) and is used in disaster recovery situations where the router has no valid Cisco IOS software or bootflash image to boot from and hence, only boots up in ROMmon. Refer to Cisco Technical Tips Conventions for more information on document conventions. If your network is live, make sure that you understand the potential impact of any command.

All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. Note:В Xmodem can also be used on certain Catalyst switches. The information in this document is based on these software and hardware versions:Д¬isco 827, 1600, 1700, 2600, 3600, and 3700 Series RoutersД¬isco AS5200, AS5300, AS5350, and AS5400 Universal Access Servers There are no specific requirements for this document.

#Putty ymodem file transfer how to

This document explains how to use the xmodem command at the console to download Cisco IOSВ® software using the ROM monitor (ROMmon).